VDO Cyclecomputing C3 Uživatelský manuál stáhnout pdf (Strana 19)

b. When mounting the sensor on a suspension fork, don’t forget to allow extra length for the

cable.

WATCH OUT: cable may tear

step 1 Loosely attach the sensor on the fork leg with cable ties

(do not tighten yet).

step 2 Mount the magnet on a spoke. Adjust the magnet to the

marking on the sensor (distance 1-5 mm).

step 3 when unit is working, ﬁnalize transmitter and magnet

mounting by tightening cable ties and clamping the

magnet

2.2 Mounting cable and VDO “any-size” handlebar holder

step 1 Run the cable up the fork, pass it around the brake cable from the already ﬁxed sen-

sor to the handlebar. Use the enclosed cable ties or duct tape. Spiral the wire around

the brake cable (this has proven to be the best solution).

step 2 position the holder on the handlebar.

>>> P03

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 50 51

Žádné komentáře

VDO Cyclecomputing C3 Uživatelský manuál Strana 19