VDO Cyclecomputing C3 Uživatelský manuál stáhnout pdf (Strana 20)

step 3 feed the ﬁxing clamp through the slot below the holder socket, pass the clamp

around the handlebar and tighten it with a small screw driver. Do not overtighten, the

plastic screw might be damaged. Readjust the cable so that it will not be stretched

during steering. Finally tighten the zip ties holding the sensor.

2.3 Battery Installation (computer)

Your VDO computer comes with a 3 V battery (type 2032).

step 1 insert the battery into the computer, positive pole face-up

step 2 watch out not to edge over the battery

step 3 watch out that the rubber washer lies levelled on the inside

of the battery compartment.

step 4 insert the battery door into the opening, twist it with a coin

to the right until the stop after approx. 1/3 turn.

Battery Change

TIP: VDO recommends an annual battery change. Buy the spare battery from your Bike Shop

>>> P04

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 50 51

Žádné komentáře

VDO Cyclecomputing C3 Uživatelský manuál Strana 20